Two Vehicles Available for Immediate Delivery


- 26 Tonne low profile beavertail body, battery and powerpack set up.



- Mercedes Arocs 2533L 6x2 Day Cab
- Prepared with Bodybuilders electric module, drawbar electrics



- Sub frame provided with crane fit
- I Beam cross members are outrigged from subframe to create a very strong low profile assembly
- Side raves constructed from outward facing channel with lashing bars at 1m centres



- Full width steel frame to approximately 650mm high
- In-filled with nominal 29mm keruing hardwood
- Grab handle to cab side of headboard
- Storage sockets for edge protection posts
- Tow ball on headboard (ball and pin)



- Maximum legal length and width
- Nominal 29mm keruing hardwood floor throughout
- 12t rated lashing rings recessed into bed at 1m spacing back from headboard
- Pair of ISO Twistlocks at 600mm rear from headboard
- Chassis mounted toolboxes N/S and O/S
- 3 point access with dropdown ladder to front of body both sides, painted hi-vis yellow, with non-slip steps and grab handle to headboard and post
- Hydraulically operated extending walkway with edge protection system to both sides on flat deck area. Until axle, where edge protection becomes swing out without walkway. Edge protection



- Pair of hydraulic cheesewedge ramps
- In-filled with nominal 29mm keruing hardwood
- Pair of hydraulic steady legs mounted at the rear of chassis operating sequentially with ramps



- Warrior C4000EN electric winch mounted at the front of the deck as far forward as possible
- Supplied with wander lead and radio remote control
- Winch protection framework as required
- Supplied with snatch block and anchor point



- Stamped and installed to meet the latest Whole Vehicle Type Approval regulations
- Original truck lights used
- Side markers, reflectors and conspicuity tape supplied
- LED amber ramp markers visible when ramps lowered



- Mudguards and side-guards supplied and installed in accordance with Whole Vehicle Type
- Approval directives
- Rear under-run protection to latest WVTA regulations



- All bodywork thoroughly cleaned prior to painting
- Two pack paint primer and topcoat applied
- Body painted single solid colour, Black RAL9005. Edge protection posts and access ladder hi-vis yellow



- Hydraulic upgrade for ramps, walkways
- 2 x LED work lights to rear of headboard
- 2 x LED grill mounted amber warning strobe lights
- 2 x LED rear mounted LED amber warning strobe lights
- Colour reverse camera and in-cab monitor